Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
ES Windows Impact Garage Doors: The Lantana Owner’s Guide
We stock and install ES Windows-compatible impact garage doors in Lantana, with most replacements running $2,800-$4,600 installed depending on door size, wind-load rating, and hardware series. Most ES Windows impact garage doors we measure in Lantana are ordered within 48 hours and installed once the unit clears local wind-load inspection. Homeowners usually discover trouble when the door hangs uneven in the track, the automatic opener strains or reverses mid-cycle, or they spot corrosion blooming where the bottom seal meets the driveway after a wet season.
Which ES Windows Models This Applies To
ES Windows manufactures impact garage doors under the StormSecure and CoastalShield series lines, both rated for Miami-Dade HVHZ standards. The StormSecure 150 and 200 series use 2-inch track hardware with reinforced bottom brackets; the CoastalShield 300 and 400 series step up to 3-inch heavy-duty track and upgraded torsion spring systems rated for higher cycle counts. To identify your unit, check the aluminum frame edge for a stamped series label, or measure the track width where the rollers sit. The model prefix (SS- or CS-) tells us which spring set, hinge grade, and bottom seal profile to order.
We are not affiliated with ES Windows. We are an independent service provider that sources OEM hardware through verified ES Windows distributors and stocks select aftermarket equivalents where the spec matches. For Lantana homes built between 2015 and 2022, we most often see the StormSecure 150 with 8′ x 7′ single-car openings; the CoastalShield 400 dominates newer construction along Hypoluxo Island and the beachfront corridor where the 180 mph wind-load rating is code-required. Aftermarket rollers and hinges from Clopay’s compatible line can save 15-20% on hardware-only jobs, but we spec OEM torsion springs and cables because the cycle rating and corrosion coating differ.
Signs Your ES Windows Impact Garage Door Is Failing

- The door shudders or binds in the track. Worn rollers develop flat spots, or track alignment shifts as the jamb settles in Florida’s sandy soil. On ES Windows units, the nylon rollers in the StormSecure series degrade faster in salt air; we replace them with sealed-bearing steel rollers on Lantana beachfront jobs.
- The opener motor labors or reverses unexpectedly. A failing torsion spring transfers load to the opener, which is not built to lift the full door weight. ES Windows CoastalShield doors run 180-220 pounds; a broken spring forces the opener to pull double duty until it burns out.
- Daylight shows under the bottom seal, or water pools inside after rain. The rubber bulb seal compresses permanently after 4-6 years of UV and heat exposure. In Lantana, we measure this at 3-5 years for west-facing doors that catch afternoon sun off the Intracoastal.
- Visible rust on cables, springs, or bottom brackets. Galvanized hardware rated for inland use corrodes faster within two miles of salt water. ES Windows hardware carries a standard zinc coating; we upgrade to stainless cable and epoxy-coated springs for Hypoluxo Island and oceanfront installs.
- The door sits crooked when closed, or gaps appear at the sides. A failed lift cable on one side lets the door hang uneven, stressing the remaining cable and bending the track. Left unaddressed, the door jumps the track entirely.
Before
AfterReplacement Cost & What’s Included
| Component | Price Range (Installed) |
|---|---|
| Full ES Windows impact garage door replacement, single-car (8′ x 7′) | $2,800 - $3,900 |
| Full ES Windows impact garage door replacement, double-car (16′ x 7′) | $3,400 - $4,600 |
| Torsion spring replacement (pair, OEM-rated) | $380 - $520 |
| Complete hardware set: rollers, hinges, cables, drums | $620 - $840 |
| Bottom seal replacement (weatherstrip only) | $180 - $260 |
What drives the range: door size, wind-load rating required by your Lantana address, and whether the existing frame and track are reusable. Full replacements include removal, disposal, new door unit, hardware, reconnection to your opener, and permit coordination if the door rating changes. Hardware-only jobs include the measured survey you keep, written scope, and our 365-Day Done Right Promise under the Haven Standard. We pull permits when required and pass inspection before final invoice. Every job leaves a documented photo record.
DIY or Call Us?

There is one safe check a homeowner can make: pull the red emergency release cord on the opener and lift the door manually. If it will not stay open at waist height, the spring balance is off. Do not proceed further.
Torsion springs store lethal energy. Winding cones can slip; cables snap under load. We have replaced ES Windows doors in Lantana where a homeowner’s socket wrench slipped during spring adjustment, bending the track and converting a $400 spring job into a $3,200 full replacement. If you are not trained on winding bars and torsion geometry, this is not a savings opportunity. It is a hospital bill.
What we handle: spring wind calculation for your door weight, track plumb to a sixteenth, opener force-limit adjustment, and the written proof that it all meets code. Call (561) 461-2062 to schedule your free estimate. We will measure, write the price, and let you decide.
FAQs
The door panel itself typically lasts 20-25 years, but hardware fails earlier in coastal Florida. Springs last 8-12 years or 10,000 cycles; rollers and cables run 5-8 years near salt air. We see faster wear on west-facing doors and homes within a mile of the beach. Call (561) 461-2062 and we will inspect yours at no charge.
Yes, if the panel is intact and the frame is square. Most ES Windows doors we service in Lantana need hardware replacement, not full door replacement. We replace springs, cables, rollers, and openers while keeping the existing impact-rated panel. We will tell you honestly if the panel is salvageable; Haven Clause 5 is no surprises.
A full door replacement takes one day; hardware-only jobs run 2-4 hours. We arrive with the measured survey already done, background-checked and uniformed crew identified by license number, and the written scope matches the quote. The 365-Day Done Right Promise covers the installation.
We carry common spring sizes, roller sets, and cable assemblies for StormSecure and CoastalShield series on every Lantana service vehicle. Full door panels are ordered to measured spec; we do not stock completed doors because every opening has a different wind-load requirement and finish. Call (561) 461-2062 to schedule your free estimate.
Sonia Raman picked up her first glazing tools at Los Angeles Trade-Technical College, where she learned to read a rough opening before she learned to drive on the freeway. She has spent the better part of two decades measuring, ordering, and installing windows and doors across South Florida, with her crew logging work on homes along the Lantana beachfront corridor that face salt air and hard summer storms every year. She is known for writing down the exact U-factor and impact rating of every unit before a contract is signed. Measure it right the first time. Everything after that is just paperwork.
Call (561) 461-2062 to schedule your free estimate. We also stock parts for PGT, CGI, and CWS impact garage doors.
Written by Sonia Raman, Owner, Sightline Windows & Doors Lantana at Sightline Windows & Doors Lantana, serving Lantana and nearby areas.










Before
After
Before
After